Install

With Ubuntu installing is very straightforward,

sudo apt-get install apache2

Apache 2.x is now installed.

Test

Verify that the Apache Web Server is running first by hitting your server's IP Address. If you do not know your ip address, at the console type,

ip address
1: lo: <LOOPBACK,UP,LOWER_UP> mtu 16436 qdisc noqueue state UNKNOWN
    link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
    inet 127.0.0.1/8 scope host lo
    inet6 ::1/128 scope host
       valid_lft forever preferred_lft forever
2: eth0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc pfifo_fast state UNKNOWN qlen 1000
    link/ether 40:40:39:1b:ec:30 brd ff:ff:ff:ff:ff:ff
    inet 173.203.126.225/24 brd 173.203.126.255 scope global eth0
    inet6 fe80::4240:39ff:fe1b:ec30/64 scope link
       valid_lft forever preferred_lft forever
3: eth1: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc pfifo_fast state UNKNOWN qlen 1000
    link/ether 40:40:33:6c:9d:19 brd ff:ff:ff:ff:ff:ff
    inet 10.179.62.235/19 brd 10.179.63.255 scope global eth1
    inet6 fe80::4240:33ff:fe6c:9d19/64 scope link
       valid_lft forever preferred_lft forever

Sometimes you may get back more than one IP address if you have more than one Ethernet card. If you are unsure, just try them one at a time in the next step. In this case mine is 173.203.126.225.

Launch a browser and enter your ip address into the browser.

You should see a default Apache webpage.

Status, Stopping, Starting, Restarting and Reload

You should know the basic commands to running Apache 2. Go ahead and try them. Note ignore the warning message about "fully qualified domain name" as that is covered in the next section.

As of Ubuntu 12, the following the basic commands to manage Apache2 are,

sudo service apache2 status
sudo service apache2 stop
sudo service apache2 start
sudo service apache2 restart # restart will restart the service (safer, as not all services support reload)
sudo service apache2 reload # reload will re-load the configuration files, with little or no downtime.  Not all services support it (source: http://askubuntu.com/questions/105200/what-is-the-difference-between-service-restart-and-service-reload)

Before Ubuntu12,

sudo /etc/init.d/apache2 status
sudo /etc/init.d/apache2 stop
sudo /etc/init.d/apache2 start
sudo /etc/init.d/apache2 restart
sudo /etc/init.d/apache2 reload

Provide Server Name

Apache is working fine, but during restart you will get the warning message, "apache2: Could not reliably determine the server's fully qualified domain name, using ...".

Most websites have a domain name attached to them. Apache is looking for this on start-up. Depending on the version of Apache and Ubuntu this can be resolved by adding the ServerName Directive with the hostname.

You can determine hostname by typing,

hostname 

Adding an entry into the Global Configuration ensures that the change will persist even if Apache is upgraded,

# create the configuration file in the "available" section
echo "ServerName localhost" | sudo tee /etc/apache2/conf-available/servername.conf
# enable it by creating a symlink to it from the "enabled" section
sudo a2enconf servername

This concept has changed over time and look here for legacy versions of Apache.

Restart Apache to confirm you do not get the warning messages,

sudo service apache2 restart

Uninstall Apache Completely

.. these instructions need to be improved, and there is nothing here about removing logs.

1. stop apache:

sudo service apache2 stop

sudo /etc/init.d/apache2 stop

2.  remove:

sudo apt-get remove apache2

sudo apt-get purge apache2

References

http://cloudservers.mosso.com/index.php/Ubuntu_-_Apache_configuration#Security_Settings - Rackspace wiki on hardening Apache Web Server.

Apache Web Server Hardening Guide - https://geekflare.com/apache-web-server-hardening-security/